[MDMagnum]

I'm still tinkering with mine. I bought a drill press (thank you harbor freight) but am having to make some redesigns. I know I need to take pictures but the prototype is very rough. The basic concept I started with was a 3in ID pvc pipe for the outer casing, capped on one end with a cleanout on the other. Down the center would be a 1in ID pvc pipe with alternating stainless wire coiling up the pipe. The problem I ran into is keeping the wires from crossing. SS wire is hard to work with. My latest change is to move to two small dowels with tightly wrapped wire with each being a separate electrode. I am going to be working on it more this week and will hopefully be bringing it to the Northern VA Chantilly M&G. It won't be installed but maybe at least operational.

I need to find some time on a lift to run the line from the rear to the front and need to select the tubing based on heat resistance.

I will warn you now that it is very rough. I'm trimming the budget until I get it working. Then I will probably commission someone else to build the pretty into the next design.

Also I'm looking into putting in a CAI so I can put a custom fitting onto the intake. If I get the exhaust as well I may be able to get my mechanic to run the tubing under the chassis but money will restrict.