Where can I find Instructions?

coolmag · 06-16-2006, 11:22 PM

Does anyone here know where I can find instructions on how to remove the front dash grill to get access to the front speaker ports.
Besides the bland freebie answer found at the bottom of this page. http://www.carstereoremoval.com/htm/...gnum05_06P.htm

cjvd0724 · 06-20-2006, 04:40 PM

Thats pretty much how you do it. It is held in with snaps if you pry the edge of the seam closest to you with a plastic pry tool (so you dont wreck your dash or your speaker cover it will just pop up. Then you can take the speaker out and install the new one.

Just make sure you use something that is not going to scratch or dent your plastic dash. A good tip is insert a flat putty knife and then your pry tool and pry towards your putty knife so you dont mark your dash up. or use a plastic pry tool if you can find one.

SoCalRT · 06-20-2006, 06:09 PM

It's pretty simple, but here it is from the manual.

To get the door panel off is a completely different story for the door speaker.

06-16-2006, 11:22 PM	#1
coolmag Junior Member Join Date: Jun 2006 Posts: 25 iTrader: (0)	Where can I find Instructions? Does anyone here know where I can find instructions on how to remove the front dash grill to get access to the front speaker ports. Besides the bland freebie answer found at the bottom of this page. http://www.carstereoremoval.com/htm/...gnum05_06P.htm

06-20-2006, 06:09 PM	#3
SoCalRT Major Mag Nut Join Date: Nov 2005 Location: Lake Elsinore, CA Posts: 3,201 iTrader: (0)	Speaker Removal It's pretty simple, but here it is from the manual. To get the door panel off is a completely different story for the door speaker.
	SoCalRT's Sig:Later, Brett Click the pic to go to my site SoCalLX - " Where Southern California Car Culture Meets Modern Mopar Muscle"

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Supporting Members do not see these ads.

06-20-2006, 04:40 PM	#2
cjvd0724 Junior Member Join Date: Jun 2006 Posts: 11 iTrader: (0)	Thats pretty much how you do it. It is held in with snaps if you pry the edge of the seam closest to you with a plastic pry tool (so you dont wreck your dash or your speaker cover it will just pop up. Then you can take the speaker out and install the new one. Just make sure you use something that is not going to scratch or dent your plastic dash. A good tip is insert a flat putty knife and then your pry tool and pry towards your putty knife so you dont mark your dash up. or use a plastic pry tool if you can find one.