Custom Dodge Magnum Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
52 Posts
Discussion Starter #1
Hi Everyone! I posted a question a few days ago, and somehow lost it! So here it is again..............anyone out there with a 2.7 V6 Magnum who's put a set of duels on or you hemi guys, have you seen any info out there about a bolt on set? Any help would make our weekend! Also, you guys with the 3.5 V6, I think mopar makes a bolt on pipe set up for your cars with a steel piece you have to slip into the rear bumper after making a cut on the lower bottom of drivers side. Anyone done this trick? I'm not scared to cut the bumper, ( I cut out a hole in my new 150 mile :sterb032: 1976 dodge Aspen R/T 360 to install a hemi cuda's shaker scoop and trim ring on it! Fit like a glove and looked bad as ) so..........any info?
 
1 - 1 of 1 Posts
Top