The SRT mouldings is available at teh dealer, but it is very expensive. Many guys have used chrome adhisve moulding cut to fit...

 

U can get it from ebay.....

Dodge Magnum Chrome Bumper Trim Made In USA Hot:eBay Motors (item 390064489471 end time Jul-10-09 20:40:56 PDT)

 

I ordered it on-line but I can't remember where I got it from... seems like it was about $40 for the set. Easy to apply just get it straight the first time because it screws it up if you try to pull it back off... I know because I had to order a second set just to get one strip.

 

I purchased a roll of "fender moulding" from Kragen Auto for about $5.00,cut each piece to length and stuckit on... Whole job took less than 30 minutes.

 

^^^^^ LOokz good and I am definitely feelin that pinstripe!!!!!

 

Did mine a while back, here's the thread. Fireman2118 (Bill) added the shortcut that I used to get mine off EBAY. I prefer the 3/4 inch ones as opposed to the 1/4 inch. Hope this helps.

http://www.custommagnums.com/forums/exterior-styling/20233-bumper-inserts-done.html

 

Did mine a while back, here's the thread. Fireman2118 (Bill) added the shortcut that I used to get mine off EBAY. I prefer the 3/4 inch ones as opposed to the 1/4 inch. Hope this helps.

http://www.custommagnums.com/forums/exterior-styling/20233-bumper-inserts-done.html

Actually The above post links to the ebay page that has the 5/8" strips, pre cut for front and back. You want the 5/8" strips if you can get them.
The 5/8" strips are a perfect match to the OEM bumper strips, size wise.

 

Whoops. Typo. I did mean 5/8 NOT 3/4 inch. Thanks for the correction Bill. I now have to either stop posting or stop drinking....so good night all.

 

You can also buy the molding at Auto Zone with the adheasive back and just cut to size! We plan on doing this to Tee R/T (ANGEL) sometime soon!