[SoCalRT]

The ride is looking great and getting closer to completion each day...nice write up...

 

[clarka802]

Looks Great!! but whats going on around the fog lights? did you seal them up?

 

[bubbamagnum]

Yes, they were filled in and I am mounting some fog lights in the lower grill cut out. I will be doing some more molding on Monday and Tuesday to finish the lower grill area.

 

[riperoo]

Man, I abasoulutely, can not wait to see this rig when it is done.... amazing work!!! And beans for the write up.

 

[MoPower]

That is a great write up, thanks for the information, I learned a thing or two for sure! If I ever make a full fiberglass nose, it will have to look like that!

 

[bubbamagnum]

Thanks Mo, I am glad you made by to check out my work on your work!!

 

[1blkperl]

nice write up . and nice nice work

 

[ktmp]

Can't wait to see it done. Attention to detail is always huge. Nice write up. THANKS

 

[DeadDog]

Its done and it looks HOT! There are pictures of it at a show or something around here...

 

[Prospector]

Terrific "How To".... did not realize there was so much preparation involved

 

[RAWphenom]

talk about a thread brought back from the dead

 

[DaMAG-nificent]

Thanks for this

 

[Danish Lowrider]

a easy way (I have do)

1) Mont the Danko front as normal (screw on)
2) Tape (use good stong tape) the gap outside (so the epoxy supp dont run out)
3) Buy "2" litters boat epoxy (a littel fiber mat are also ok to use)
4) tune the bumper upside down, use all the "2" litters epoxy
5) after a couple of hours remove the tape in front. (you will se a perfekt gap fill out)
6) grind and spartel a little in front.
Strong as hell It never come off again

 

[MoPower]

a easy way (I have do)

1) Mont the Danko front as normal (screw on)
2) Tape (use good stong tape) the gap outside (so the epoxy supp dont run out)
3) Buy "2" litters boat epoxy (a littel fiber mat are also ok to use)
4) tune the bumper upside down, use all the "2" litters epoxy
5) after a couple of hours remove the tape in front. (you will se a perfekt gap fill out)
6) grind and spartel a little in front.
Strong as hell It never come off again

got any pictures?

 

[Danish Lowrider]

No sorry, I have forgot to do pictures

 

[Skizza]

Pictures not of the "how-to", but of the finished product?

 

[PeterMartin]

Thanks for sharing such a descriptive post but the pictures are too big in the size It took me a lot of time to get lode and to have a close look.